首页 > 产品信息 > 电器、照明 > 照明 > LED灯

KiaLED The most powerful LED Area lighting

KiaLED are made with the light weight and bright Lumen LeDwali modules. Because of these unique modules U-Tron can bring you the most powerful LED lights you can find in the market today. These lights well exceed the 300 Watt mark but still keeping the weight under 10KG. And that is a very remarkable breakthrough in our industry. Furthermore, thanks to Dr. Lin and his team for the “Chips & Lens” design, this made possible to eliminate the glass cover to increase another 10% of the Light output. And it’s an all in all IP66 design to bring you worry free use of many years, indoor or outdoor.

1.       Remove and save the 4 bolts on the top of the Cable box (You will need one Philips 1/4in screw driver.) Inside the Cable box locate the two 3 pin Connectors and the Ground wire connector as shown in the fig 1

2.       Recommended power cable from the hand hole to the luminaries shall be 2 - #12 copper NMWU with ground, CSA approved. (Customer provided)

If you are installing the KiaLED go to step 3. If you are installing ParkLED skip 3 and 4 and go to step 5

3.       Insert the power cable from the pole through the twistable arm and then through the cable gland on the cable box as shown in the Fig 2.

4.       When inserting the power cord through the light please use the supplied nylon cable protection tube to avoid prolonged friction of cable against the metal hole on the light. Its not necessary to fasten this tube as long as its stays half way inside the twistable arm

5.      

6.       Unlike the KiaLEDs you can directly attach the ParkLEDs to the poles. Please refer to the diagram shown on Figure 3.

7.       Live wire or the black wire goes to the 3rd position of the 3 pin connector of the black wire connector. You must open the lever to insert the wire and close it to secure the wire.  See Figure 4. Pull and test to make sure the wire is indeed securely fastened and holding in the hole. Loose wires will cause poor performance or burnout.

8.       Follow the same with the white wire or the neutral wire.

9.       insert the ground wire into the single wire connector which is connected with the yellow/green wire and 3 pin described above. Squeeze the connector to insert the cable and release it to snap inside. Pull and see if the wire is indeed holding in the hole.

10.