首页 > 产品信息 > 工业设备 > 食品饮料和粮食加工机械

JS999-03 香肠剪节机 剪结机 剪肠机 根成机械制造

剪节机主要用来切割由天然和人造肠衣灌装扭结的肠节。尤其是很短的产品如鸡尾肠和火锅肠的切割更显高效。可设置对一串肠进行单根切割和成串切割，成串切割每串的根数可任意设定。可定长切割，即把无肠节的肠切成均匀的小段，最小长度25毫米。可自动累计计算切割的根数，计数器可清零。可即时显示每分钟切割的根数和肠的长度。有无操作后定时停机功能。

Sausage twist cutting machine with transportation belt is used for cutting sausage twists of both natural casing and man-made casing.  It specially high efficiency to cut very short cocktail sausage and hotpot sausage.  It can cut piece by piece or a string of pieces. The number of pieces in a string can be set on screen. It can also cut by set length, which means that long sausage without twists can be cut into set length of pieces. Minimum length is 25mm.  Total number of pieces is displayed on screen. The counter can be reset.  Number of pieces in minute and actual sausage length can be displayed instantly.  Machine can automatically stop after set time without cutting.

　　　剪节机主要技术指标：

　　Important Specifications

　　1.肠节由红外光电传感器自动检测，切割次品率低于3‰；切刀根据检测结果自动以极快的速度启动切割，保证了切割的准确和快速。大大提升了产品档次。不需要预先设定肠的长度。

　　Sausage twists are automatically detected by infra-red sensor.  Scrap rate is less than 3‰。The knife is started at very fast speed when a twist is detected.  It can insure very fast and accurate cutting.  Final product looks more attractive.   It is not necessary to set sausage length.

　　2.可在触摸屏上设定传送带的速度。

　　Belt speed can be set on screen.

　　3.可对切割位置进行优化。

　　Cutting position can be optimized.

　　4.肠的直径范围10 - 45毫米，定长切割时最大直径30毫米。肠的最小长度25毫米，最大长度不限。皮带输送速度根据顶板的规格和肠的长度确定，最大速度可达1.8米/每秒。短肠时切割速度可达1800根以上

　　Sausage diameter can be in the range between 10 - 45mm.  Maximum diameter can be up to 30 mm when machine works in fixed length cutting mode.  Minimum sausage length is 25mm and no upper limit.  Belt speed depends on sausage length and top plate being used.Maximum speed is 1800mm per minute.  It can cut  more than 1800 pieces per minute with very short product

　　5.极大程度上缓解了工人的劳动强度。

　　It can largely improve labor intensity.

The specifications and performance is the same with INOTECH Germany Brand.